![]() ![]() ![]() To maintain a proper water seal, replace the ring with an approved spare. Long-term use can result in O-ring wear.Unscrew the tail cap or remove the battery to prevent accidental activation during storage or transportation.If the light will not be used for an extended period, remove the battery for proper storage.Fenix recommends using only a high-quality protected battery.Disassembling the sealed head can cause damage to the light and will void the warranty.Usage and Maintenance for the Fenix PD 35 V3.0 Flashlight When this happens in Eco output, the battery level indicator blinks red 3 times every 10 minutes to remind you to recharge or replace the battery. When the voltage level drops below the preset level, the flashlight is programmed to downshift to a lower brightness level until Eco output is reached. When the temperature drops below 60☌, it will then allow the user to reselect the modes. When the light reaches a temperature of 60☌ or above, the light will automatically step down a few lumens to reduce the temperature. The light will accumulate a lot of heat when used at relatively high modes for extended periods. Note: This only works with Fenix ARB-L18 series 18650 battery. Green light flashes: sufficient 85% - 50%.Only use quality batteries with circuit protection will reduce the potential for combustion or explosion but cell damage or short circuiting are potential risks the user assumes.īattery Replacement Unscrew the light tail and insert the battery with the anode side (+) towards the light head, then screw the light tail back on.īattery Level Indication Each time the light is turned on the indicator in the functional side switch will indicate the battery level and will last for 3 seconds. * 18650/ 16340 Li-ion batteries are powerful cells designed for commercial applications and must be treated with caution and handled with care. Doing so may cause damage to the flashlight or the batteries being used. Warning: Do not mix batteries of different brands, sizes, capacities or types. When turned on again the previously used output of general mode will be recalled. The light memorizes the last selected output excluding strobe. With the light switched on, press and hold the functional switch for 0.5 seconds to enter strobe, single click again to turn back to previously used output on general mode.With the light switched on, single click the functional switch to cycle through Turbo→Eco→Low→Med→High.Fully press the tactical switch to constantly turn on the light, press again the light will go out.Tap the tactical switch to momentarily turn on the light, release the light will go out.The tail switch is the tactical switch and the side switch is the functional switch. Switches of the Fenix PD35 V3.0 Flashlight ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |